Sweep & inspection
Caps & crowns
Masonry repairLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Yonkers?
Chimney liner and rebuild work in Yonkers, NY typically runs between $2,800 and $8,500 in 2026, with most homeowners paying around $4,200 for a standard stainless steel liner replacement combined with moderate masonry rebuild work. A standalone chimney liner installation usually costs $1,800 to $4,000, while a full chimney rebuild (from the roofline up) ranges from $5,000 to $15,000 depending on height and access. These numbers reflect what we see across Yonkers neighborhoods like Getty Square, Park Hill, Dunwoodie, Crestwood, and Bryn Mawr, where older housing stock means chimneys are often 60 to 100 years old and were built with lime mortar that weakens faster than modern Portland cement mixes.
Chimney Liner & Rebuild Cost Breakdown (2026)
Here’s a line-by-line breakdown of what chimney liner and rebuild work costs in Yonkers right now. These are the actual ranges we quote in this market, not national averages that get pulled in from somewhere else.
| Service | Typical Cost in Yonkers | What’s Included |
|---|---|---|
| Chimney inspection (Level 1) | $150 – $300 | Visual check of firebox, damper, flue interior, exterior masonry |
| Chimney inspection (Level 2, with camera) | $350 – $600 | Camera scan of flue liner, often required before liner replacement |
| Stainless steel liner (DuraFlex or similar) | $1,800 – $4,000 | Liner kit, insulation wrap, top plate, rain cap, labor |
| Heatshield cerfractory liner repair | $2,200 – $4,500 | Ceramic sealant resurfacing of existing flue, for homes where liner damage is moderate |
| Partial chimney rebuild (top 5-8 courses) | $2,500 – $5,500 | Tear down and rebuild upper brick courses, new crown, flashing check |
| Full chimney rebuild (above roofline) | $5,000 – $12,000 | Full tear down and rebuild, new liner often included, new crown, new flashing |
| Chimney crown replacement | $750 – $1,800 | Remove old cracked crown, pour new concrete or steel crown |
| Chimney flashing repair/replacement | $500 – $1,400 | Remove old flashing, install new step and counter flashing at roofline |
| Retuckpointing (per 10 sq ft) | $400 – $900 | Repointing mortar joints in brick, mortar color matched to original |
| Combined liner + partial rebuild | $3,500 – $7,500 | Most common package in Yonkers: new liner plus upper-stack rebuild |
Those numbers assume straightforward roof access. Yonkers homes create specific cost variables that most national guides ignore. A chimney that rises above a steep slate roof in Park Hill costs more to work on than one surrounded by a shallow asphalt shingle pitch in Lincoln Park. Scaffolding is a real line item here, and on streets where homes are built close together with zero side-yard access, staging and ladder setup can add $300 to $800 before anyone touches a trowel.
One more thing that matters: off-season timing. Chimney work in the Hudson Valley gets cheaper between April and August, when demand drops. We’ve seen liner replacement quotes come in 10% to 18% lower in mid-summer than in October and November, when every homeowner in Yonkers simultaneously realizes their furnace flue is falling apart right before heating season.
What Affects Chimney Liner & Rebuild Pricing in Yonkers
No two Yonkers chimneys price the same, and here’s why. These five factors are what move your number between the low end and the high end of those ranges:
- Roof pitch and chimney height. Yonkers has some of the steepest residential roof pitches in Westchester County, especially in the hill sections around Crestwood and Cedar Knolls. A 10/12 pitch roof requires staging and safety lines that a 6/12 pitch doesn’t, and that labor difference hits the quote directly. Taller chimneys (three stories up, like many Victorians in Getty Square) also require more time and more material.
- Age of the brick and mortar. Homes built before 1940 in Dunwoodie and Nodine Hill typically have soft salmon brick and lime mortar. Lime mortar doesn’t bond well with modern concrete repair mixes, so the mason has to custom-blend a compatible mortar, which adds $200 to $600 in material and mixing time on a rebuild job.
- Liner type and fuel source. A gas furnace flue needs a smaller, simpler liner than an open wood-burning fireplace. If you burn wood, you’ll need a liner rated for 2,100°F flue gases (like a DuraFlex 316Ti alloy), which costs more than the standard 304 alloy used for gas-only applications.
- Permit status. Yonkers Department of Housing and Buildings requires a permit for any structural rebuild, and inspections are part of that process. The permit itself is typically $100 to $300, but the bigger cost is scheduling: inspectors in Yonkers can be booked out 5 to 10 business days during peak season, which extends the project timeline and labor hours.
- Flue accessibility and existing liner condition. If the old clay tile liner has cracked, collapsed, or shifted (which we see constantly in Bryn Mawr and Homefield, where freeze-thaw cycles are brutal on chimneys), removal is more labor-intensive. In some cases, the old clay tiles have to be broken out by hand before a new liner slides in, adding $400 to $1,000 to the job.
If you’re reading this from a home on the Hudson River side of Yonkers, add one more factor: wind exposure. Chimneys within a mile of the river get hit with driven rain and salt air, which accelerates mortar erosion and means rebuild work often extends further down the stack than it would five miles inland.
How to Save on Chimney Liner & Rebuild
You can’t skip necessary chimney work, but you can avoid paying more than you need to. Here’s what actually works in Yonkers:
- Get the chimney inspected in spring or early summer. You’ll have better scheduling availability, faster permit processing, and often lower pricing than the September-to-December rush. The off-season discount is real.
- Combine jobs. If you need a rebuild and a new liner, doing both at once is cheaper than staging them across two visits. The scaffold is already up, the permit is already pulled, and the crew is already on the roof.
- Ask for a written, line-item quote before work starts. At Hadley Chimney Yonkers, every job gets a written price before anything starts. That means no mystery surcharges when the tech is already on the roof and no “discovered additional repairs” that triple the bill. If a company won’t put their price in writing before starting, that’s a red flag.
- Don’t auto-accept a full rebuild quote if a partial rebuild will do. Some older homes only need the top few courses rebuilt plus a new crown. A good camera inspection will show the difference. We always share those photos with you because you shouldn’t have to take anyone’s word for what’s happening 30 feet above your roofline.
- Address flashing and crown issues early. The most expensive rebuilds we do in Yonkers are on chimneys that should have had a $1,200 crown replacement five years ago. Water intrusion is the root cause of most structural chimney failure, and it compounds fast in the Hudson Valley’s freeze-thaw winters.
If you want a real number on your specific chimney, call us at (914) 233-3156. Estimates are free, and you’ll get a written price before any work starts, not a ballpark that “might go up.”
Why Chimney Liners Fail in Yonkers Specifically
This is where most pricing guides go generic, and it’s the part that matters most for Yonkers homeowners. Your chimney liner isn’t failing for the same reason a liner fails in Phoenix or Dallas. It’s failing because of freeze-thaw cycling, which is a bigger problem here than almost anywhere else in New York State outside the Adirondacks.
Here’s what happens: your furnace or boiler runs all winter, sending warm, moisture-laden exhaust up through the flue. That moisture condenses on the inside of the liner, soaks into the clay tile and the mortar around it, and then when the chimney cools between burn cycles, the trapped water freezes and expands by roughly 9%. Over 40 or 50 winters in Yonkers, where we average 90-plus freeze-thaw days per year, that repeated expansion and contraction cracks clay tiles and spalls brick faces from the inside out. If your home was built between 1920 and 1980 (which covers the vast majority of single-family stock in Getty Square, Dunwoodie, and Park Hill), your original clay tile liner was never designed to handle the moisture output of a modern high-efficiency furnace, and it’s likely degrading faster than anyone realized.
If you have a wood-burning fireplace in Crestwood or Bryn Mawr, the issue is the opposite: years of creosote buildup (the flammable tar residue that coats flue walls during wood combustion). Creosote is acidic. It etches into clay tile, compromises the liner’s integrity, and at worst, it becomes the fuel source for a chimney fire. That’s why a camera inspection before liner replacement is non-negotiable in our book. You can’t see what’s happening inside a 30-foot flue from the ground, and anyone who quotes a liner replacement without putting a camera up there is guessing.
What Happens When You Book With Hadley Chimney Yonkers
Here’s what the process actually looks like, step by step, because we think you should know exactly what to expect before you pick up the phone:
- You call (914) 233-3156. A live person answers. Not a voicemail, not an answering service, not a callback queue. 24/7, someone picks up and books your appointment.
- We send a background-checked, uniformed technician in a tracked arrival window. You’ll know who is coming, what time, and when they’re 15 minutes out. The Relay Visibility Guarantee is built into every visit.
- The tech performs a full inspection and documents everything with photos. We run a Level 1 or Level 2 camera inspection depending on your situation, and you see the photos. We don’t ask you to take our word for it.
- You get a written price before any work starts. Not a verbal estimate, not a range, not a “we’ll see once we get up there.” A written price. If the work expands, we tell you before anything changes.
- We do the work, show you the after photos, and send a digital invoice. You can pay from the link. No paper check, no envelope, no “the office will call you.”
- Your repair is covered by the 365-Day Done Right Promise. If it’s not done right, we make it right, and every repair comes with a written guarantee plus a free second visit if the repair fails. That’s not a promotional offer; it’s the way we work as part of Relay Home Co., held to The Relay Standard.
We work with DuraFlex flexible liner systems, HeatShield ceramic repair compound, Gelco, Olympia Chimney, Famco, and Copperfield products because those are the materials chimney professionals actually trust for long-term performance. We don’t use whatever is cheapest on the truck that week.
Frequently Asked Questions About Chimney Liner & Rebuild Cost in Yonkers
How much does a chimney liner replacement cost in Yonkers, NY?
A chimney liner replacement in Yonkers typically costs $1,800 to $4,000 for a standard stainless steel liner installed, including materials, insulation, and labor. The final number depends on flue size, fuel type (gas vs. wood), roof access, and whether the existing clay tiles need to be broken out first. At Hadley Chimney Yonkers, we give a written price before work starts so you know the number up front. Call (914) 233-3156 for a free estimate on your specific chimney.
How much does a full chimney rebuild cost in Yonkers?
A full chimney rebuild above the roofline in Yonkers runs $5,000 to $12,000, with most jobs landing around $7,500 to $9,000 for a two-story home. That includes tear-down, new brick to match the existing masonry, a new crown, new flashing, and often a new liner. Steep rooflines, third-story chimneys, or slate roofs push the price toward the top of that range.
Is it cheaper to repair or replace a chimney liner?
In Yonkers, repairing a liner with a product like HeatShield cerfractory compound costs $2,200 to $4,500, while full stainless steel replacement runs $1,800 to $4,000. The math is counterintuitive: in many cases, full replacement is actually cheaper than repair because repair work requires more labor hours inside the flue. A camera inspection tells you which option makes sense. If your liner has more than 30% structural damage, replacement is almost always the better investment.
Can you fix a chimney in the winter in Yonkers?
Yes, we work year-round in Yonkers, including winter. The challenge with winter masonry work is that mortar needs temperatures above 40°F to cure properly, so rebuild work may depend on weather windows. Liner installation inside an existing flue is less weather-sensitive and can usually be done in any season. If you have an active leak or confirmed liner damage in January, call us at (914) 233-3156 – we’ll get a tech out to assess it.
Do I need a permit for chimney work in Yonkers?
Structural chimney rebuilds in Yonkers require a permit from the Yonkers Department of Housing and Buildings, which typically costs $100 to $300. Liner-only replacement inside the existing flue usually doesn’t require a permit if no structural masonry is being changed. When we handle the rebuild, we manage the permit process as part of the job so you don’t have to navigate the city’s paperwork yourself.
How long does chimney liner and rebuild work take?
Most combined liner and partial rebuild jobs in Yonkers take 1 to 3 days on site. A liner-only install is often done in 4 to 6 hours. Full rebuilds can run 3 to 5 days, depending on weather and permit inspection scheduling. We’ll give you a timeline along with the written price before anything starts.
What You Should Do Next
If your chimney is showing signs of trouble – spalling brick on the lawn, water stains on the ceiling near the flue, a smoky smell when the furnace kicks on, or visible cracks in the crown – don’t wait. Every month of water intrusion in a Yonkers winter is another freeze-thaw cycle doing damage. Call (914) 233-3156 and we’ll get you on the schedule with a written price, a live arrival window, and photos of everything we find. Founded in 2003, led by Cory Mitchell, and operated under The Relay Visibility Guarantee as part of the Relay Home Co. family, Hadley Chimney Yonkers serves homeowners throughout the city, from home base in Westchester to the riverfront at Getty Square. For details on our full liner and rebuild process, see Chimney Liner & Rebuild in Yonkers.
Written by Cory Mitchell, Owner at Hadley Chimney Yonkers, serving Yonkers since 2003.
Pricing reflects the Yonkers market as of 2026. Hadley Chimney Yonkers offers free estimates – call (914) 233-3156.
What Our Customers Say
"Gas fireplace wouldn't light. He replaced the thermocouple and cleaned the pilot. Works every time."
- Ivan M."Drop cloths down, no soot anywhere. Booking was the easiest part."
- Susan B."Chimney repair on loose bricks, done in a morning. Tracked the crew arrival from my phone."
- Colin V.